These belts are made by fiting chains to both sides of ordinary Wire conveyor belt.Belt and chain are synchronized through Stays(cross supports).

Attachment type

Flat bar type
Chain with atachment is used.Flat bar is fitted to attachment at both sides.Flat barIs passed inside spiral(as with stay pin type)or belt is put on flat bar.Spacer must Be provided between attachment base and flat bar so that belt is positioned at same  Level as chain center.

Angle channel type This type is used to prevent deflection in case chain c/cis wide and suppor rail can
Not be installed. The same installation procedure as that applied to flat bar is applied.

Pipe type Similar to angle type. With pipe type ,however,it is necessary to crush pipe engs so As to fit to attachment.If EP type chain is used,the same assembling procedure as Stay pin type can be applied. In this case, weight is reduced and deflection in Direction lr width is suppressed.